|
1. Weaken Nuts of fastening of the corresponding wheel. The car also establish to Poddomkratta it on props. Remove a wheel.
2. Release a spherical support from a rotary fist (see the Section Removal and installation of a control lever of a forward suspension bracket).
3. Give three nuts of fastening of a support to a fist. Disconnect a support from a control lever.
4. Installation is made upside-down. Track that all fixture was tightened with the required effort. Do not forget to replace the forelock.
|
|
If for combination of grooves of a crown with an opening under landing of the forelock the provision of a nut needs to be corrected, bring up her on the required corner, - at all do not weaken. |
5. Establish into place a wheel, lower the car on the earth and tighten wheel nuts with the required effort (see the Head Nastroyki and routine maintenance). |