|
1. Weaken wheel nuts, the car and install to a poddomkratta it on props. Remove the corresponding wheel.
2. Remove a brake disk / reel (see the Head the Brake system).
|
|
3. Partially screw a nut on the hairpin which is subject to replacement. Squeeze out a hairpin of a flange of stupichny assembly by means of the special tool.
1 — the Stupichny flange
2 — the Wheel nut
3 — Strubtsina |
|
|
4. Fill a hairpin in a stupichny flange (from a reverse side of the last), install the remote plug / several flat washers and screw a nut on a hairpin.
1 — the Stupichny flange
2 — the Remote plug |
5. Tighten a nut until the hairpin completely does not sit down in a flange.
6. Establish into place a brake disk / reel. Lower the car on the earth and tighten wheel nuts with the required effort (see the Head Nastroyki and routine maintenance). |