Nissan Maxima QX

since 1993 release

Repair and operation of the car



Nissan Maxima QX
+ Cars of the Nissan Maxima brand
+ Maintenance instruction
+ Settings and routine maintenance
+ Engine
+ Cooling systems, heating
+ Power supply system and release
+ Engine electric equipment
+ Control systems of the engine
+ Transmission
+ Coupling and power shafts
+ Brake system
- Suspension bracket and steering
   General information
   Removal, check of a state and installation of rack-mount assemblies of a forward suspension bracket
   Replacement of the shock-absorber / screw spring of rack-mount assembly
   Removal and installation of assembly of a rotary fist with a nave
   Removal and installation of assembly of a forward nave with the wheel bearing
   Removal and installation of the forward stabilizer of cross stability
   Removal and installation of a control lever of a forward suspension bracket
   Replacement of spherical support
   Removal, check of a state and installation of racks of a back suspension bracket
   Removal and installation of assembly of a back nave with the wheel bearing
   Removal and installation of a bar of the back stabilizer of cross stability (models 1993 and 1994 of of the issue)
   Removal and installation of levers of a back suspension bracket (models 1993 and 1994 of of the issue)
   Removal and installation of components of a back suspension bracket of models since 1995 of the issue.
   Removal and installation of a steering wheel
   Removal and installation of tips of steering drafts
   Replacement of protective covers of assembly of the steering mechanism
   Removal, dismantle and installation of rack transfer
   Removal and installation of the steering pump
   Removal of air from a hydraulic path of system of strengthening of a wheel
   Replacement of wheel hairpins
   Wheels and tires - the general information
   Angles of installation of wheels
+ Body
+ Onboard electric equipment



Replacement of protective covers of assembly of the steering mechanism

 PERFORMANCE ORDER

1. Weaken nuts of fastening of the corresponding wheel. A car front also establish to Poddomkratta it on props. Remove a wheel.
2. Remove from a bar of steering draft a tip and its lock-nut (see the Section Removal and installation of tips of steering drafts).
3. Having squeezed flat-nose pliers lock uvulas remove collars of fastening of the external ends of protective covers of a case of rack transfer. Wire bandages of fastening of the external ends of covers it is necessary to have a bite bokorezam.

4. Before installation of a new cover wind the cut end of steering draft with an adhesive tape incidentally not to damage small sponges of a cover when landing it on draft.
5. Put on a new cover draft and pull it on a crater of the steering mechanism, having tracked correctness of landing of sealing sponges in a reception flute. Fix a cover, having imposed a wire bandage two shlaga.
6. Remove an adhesive tape and screw on the place a tip of steering draft (see the Section Removal and installation of tips of steering drafts).
7. Establish into place a wheel. Lower the car on the earth and tighten wheel nuts with the required effort (see Specifications to the Head Nastroyki and routine maintenance).