Nissan Maxima QX

1. Weaken nuts of fastening of the corresponding wheel. Cock the parking brake, prop up antiretractable boots back wheels, then a front of the car and establish to a poddomkratta it on props. Remove a wheel.

2. Holding a draft tip from a provorachivaniye the second key, release a lock-nut. Turn off a nut so that there was an opportunity to put a tag of provision of a tip on open rounds of a carving of a bar.

3. Take the forelock and weaken a nut of a spherical finger of a tip. It is not necessary to remove a nut still finally.

4. By means of a 2-gripping stripper release a sharovy finger of a tip from the lever of assembly of a rotary fist. Remove a nut and separate draft from a fist.

5. Turn off a tip and remove it from a draft bar.

1. Screw on draft a new tip (to the landing tag put in the course of dismantle on bar carving rounds). Put a sharovy finger of a tip in the lever of a rotary fist. Strongly tighten a lock-nut.
2. Screw a koronchaty nut of a spherical finger and tighten it with the required effort. Record a nut the new forelock.
3. Establish a wheel, lower the car on the earth and tighten wheel nuts with the required effort (see Specifications to the Head Nastroyki and routine maintenance).
4. Drive away the car in a specialized workshop for check and adjustment of angles of installation of forward wheels.