Nissan Maxima QX

since 1993 release

Repair and operation of the car



Nissan Maxima QX
+ Cars of the Nissan Maxima brand
+ Maintenance instruction
+ Settings and routine maintenance
+ Engine
+ Cooling systems, heating
+ Power supply system and release
+ Engine electric equipment
+ Control systems of the engine
+ Transmission
+ Coupling and power shafts
+ Brake system
- Suspension bracket and steering
   General information
   Removal, check of a state and installation of rack-mount assemblies of a forward suspension bracket
   Replacement of the shock-absorber / screw spring of rack-mount assembly
   Removal and installation of assembly of a rotary fist with a nave
   Removal and installation of assembly of a forward nave with the wheel bearing
   Removal and installation of the forward stabilizer of cross stability
   Removal and installation of a control lever of a forward suspension bracket
   Replacement of spherical support
   Removal, check of a state and installation of racks of a back suspension bracket
   Removal and installation of assembly of a back nave with the wheel bearing
   Removal and installation of a bar of the back stabilizer of cross stability (models 1993 and 1994 of of the issue)
   Removal and installation of levers of a back suspension bracket (models 1993 and 1994 of of the issue)
   Removal and installation of components of a back suspension bracket of models since 1995 of the issue.
   Removal and installation of a steering wheel
   Removal and installation of tips of steering drafts
   Replacement of protective covers of assembly of the steering mechanism
   Removal, dismantle and installation of rack transfer
   Removal and installation of the steering pump
   Removal of air from a hydraulic path of system of strengthening of a wheel
   Replacement of wheel hairpins
   Wheels and tires - the general information
   Angles of installation of wheels
+ Body
+ Onboard electric equipment

Removal of air from a hydraulic path of system of strengthening of a wheel

 PERFORMANCE ORDER

1. After implementation of any procedures connected with a detachment of lines of the hydraulic booster it is necessary to remove air from a hydraulic path of PAS. Otherwise efficiency of functioning of the steering amplifier considerably will decrease.
2. Develop forward wheels of the car in rectilinear situation and check liquid level in the PAS system tank (see the Head Nastroyki and routine maintenance). In case of need make the corresponding adjustment (level of liquid has to reach the lower point [COLD] in a tank wall).
3. A car front also establish to Poddomkratta it on props.
4. Start the engine and leave its working at turns of bystry idling. Double-check liquid level in the PAS tank. In case of need again make adjustment.
5. Here and there (without blows in the ends of the course) remove with rotation of a steering wheel from system air (you watch that liquid level in the tank during pumping did not fall below an admissible limit).
6. Having finished pumping, return wheels to rectilinear situation and let's the engine work within several more minutes, then muffle it.
7. Lower the car on the earth.
8. Make trial runs of the car, checking serviceability and noiselessness of functioning of steering system.
9. Double-check the level of hydraulic liquid at the engine which is warmed up up to the normal working temperature (this time it has to reach mark NOTES in a tank wall). In case of need make necessary adjustment (see the Head Nastroyki and routine maintenance).