|
|
Remember that the dust produced in the course of operation of brake mechanisms may contain extremely unhealthy asbestos of the person. Do not blow off dust compressed air at all and do not inhale it, - at service of mechanisms put on a protective mask or a respirator. Do not use for rubbing of components of the brake system gasoline or solvents on an oil basis at all, - apply only company cleaners or methyl alcohol! |
1. Weaken wheel nuts. A car back also establish to Poddomkratta it on props. Remove wheels.
2. Remove a brake drum / support with a disk (see the Head the Brake system).
|
|
3. Take off a protective cap of the stupichny bearing. |
|
|
5. Give a stupichny nut, remove a washer. |
6. Remove assembly of a nave with the bearing of a pin of a back axis.
|
|
7. Before installation of components into place the working surface of a pin of an axis should be greased with bearing lubricant. |
8. Installation is made upside-down. Tighten a stupichny nut with the required effort and record it the new forelock. Tighten with the required effort bolts of fastening of a support of the brake mechanism (see the Head the Brake system).
9. Establish to the place of a wheel, lower the car on the earth and tighten wheel nuts with the required effort (see the Head Nastroyki and routine maintenance). |