Nissan Maxima QX

1. Open a trunk lid. Hooking buttons of clamps the special tool, separate bottom edge of the panel of an internal upholstery of a cover for the purpose of ensuring access to assembly of a latch of the lock. Remove a plastic decorative cover of a latch.
2. Lead round assembly of a latch a marker.
3. Disconnect an electrical wiring and the executive rod connecting a latch to the lock cylinder.

4. Turn out fixing bolts and remove a lock latch.

5. Installation is made upside-down.

1. Open a trunk lid. Hooking buttons of clamps the special tool, separate bottom edge of the panel of an internal upholstery of a cover for the purpose of ensuring access to assembly of a latch of the lock.

2. Through the technological opening located near assembly of the right combined lamp release an executive rod of the lock from the clamp and remove a fixing plate of castle assembly. At the corresponding complete set of the car disconnect an electrical wiring from the lock activator.

3. Deploy the lock under 45 ° and take assembly from a trunk lid.
4. Installation is made upside-down.