1. Disconnect a negative wire from the battery.
|
If the stereosystem established on the car is equipped with a security code before disconnecting the battery make sure that you have the correct combination for input of the audio system in action! |
|
2. Turn out two screws of fastening of bottom edge of the panel of an internal upholstery. |
|
3. Having accurately hooked the screw-driver under a first line, release the control panel of functioning of the window regulator electric drive from an armrest, disconnect an electrical wiring from the taken panel. |
|
4. Remove facing of the internal handle of a door. |
|
5. Turn out the fixing screw located in a pocket of the gripping handle of an armrest. |
|
6. Having delayed the panel of an internal upholstery from a door, disunite contact sockets of the electrical wiring passing under it. |
|
7. About the ensuring access purpose in a doorframe remove the protective insulating screen, - try not to damage a film. Do not forget to return the screen into place before installation of the obivochny panel. In case of need in addition use sealant for fastening of a film. |
8. Make sure of serviceability of a state and presence on the places of all regular clamps of the panel of an internal upholstery of a door. 9. Restore initial connection of an electrical wiring and install the upholstery panel on a door. latch clamps and tighten fixing screws. Install into place the control panel of functioning of the electric drive of window regulators. |