Nissan Maxima QX

since 1993 release

Repair and operation of the car



Nissan Maxima QX
+ Cars of the Nissan Maxima brand
+ Maintenance instruction
+ Settings and routine maintenance
+ Engine
+ Cooling systems, heating
+ Power supply system and release
+ Engine electric equipment
+ Control systems of the engine
+ Transmission
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
- Body
   General information and precautionary measures
   Care of components of a body and bottom of the car
   Care of vinyl elements of finishing
   Care of an upholstery and carpets of salon
   Repair of insignificant damages of body panels
   Repair of seriously damaged body panels
   Service of loops and locks of the car
   Replacement wind and other fixed glasses
   Removal and installation of a decorative front grille
   Removal, installation and adjustment of provision of a cowl
   Removal and installation of a latch of the lock of a cowl and cable of its drive
   Removal and installation of forward and back bumpers
   Removal and installation of forward wings
   Removal and installation of the panel of a forward reflector
   Removal and installation of panels of an internal upholstery of doors
   Removal, installation and adjustment of doors
   Removal and installation of a latch, cylinder of the lock and handles of a door
   Removal and installation of door glasses
   Removal and installation of regulators of window regulators
   Removal and installation of rear-view mirrors
   Removal, installation and adjustment of a cover of the luggage compartment
   Removal and installation of a latch and cylinder of the lock of a cover of the luggage compartment
   Removal and installation of driving cables of an otpuskaniye of locks of a cover of the luggage compartment and door of the hatch of a jellied mouth of the fuel tank
   Removal and installation of the central console
   Removal and installation of finishing sections of the dashboard
   Removal and installation of sections of a casing of a steering column
   Removal and installation of the main section of the dashboard
   Removal and installation of seats
   Removal and installation of the back shelf
   Adjustment of the top hatch
   Body sizes
+ Onboard electric equipment

Removal and installation of forward wings

 PERFORMANCE ORDER

1. Open a cowl. Weaken wheel nuts, the car and install to a poddomkratta it on props. Remove forward wheels. Disconnect a negative wire from the battery.

 If the stereosystem established on the car is equipped with a security code before disconnecting the battery make sure that you have the correct combination for input of the audio system in action!

2. Remove the assembly of the index of turn put in the panel of the corresponding wing (see the Head Onboard electric equipment).

3. Turn out screws and release plastic clamps of fastening of a loker of protection of an arch of a wheel. Remove a loker together with the attached mud-chipper (mudguard).

4. Turn out bolts of fastening of the panel of a wing.

5. By means of the assistant remove the wing panel from the car, - try not to damage a paint and varnish covering.

 Having separated the panel, pull it back, removing from the guides of pins and release of an assembly bracket established from a first line from an arm of fastening of an overlay of a bumper.

6. Installation is made upside-down. At installation of a new wing transfer to it from the old panel plastic overlays of facing of an arch aperture (if those are provided).
7. Track reliability of tightening of carving fixture and a zashchelkivaniye of clamps.