Nissan Maxima QX
+ Cars of the Nissan Maxima brand
+ Maintenance instruction
+ Settings and routine maintenance
+ Engine
+ Cooling systems, heating
+ Power supply system and release
+ Engine electric equipment
+ Control systems of the engine
+ Transmission
- Coupling and power shafts
General information
Coupling - the general information and check of a condition of components
Removal and installation of the main cylinder of coupling
Removal and installation of the executive cylinder of coupling
Removal of air from a hydraulic path of the drive of switching off of coupling
Removal, check of a state and installation of components of assembly of coupling
Removal, check of a state and installation of the release bearing and lever of switching off of coupling
Adjustment of a pedal of coupling
Check of serviceability of functioning and replacement of the sensor switch of disconnection of a chain of a starter
Power shafts - the general information and check of a state
Removal and installation of power shafts
Check of a state and replacement of assembly of the basic bearing
Replacement of protective covers and check of a condition of CV JOINTS
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
|
Removal, check of a state and installation of the release bearing and lever of switching off of coupling
|
|
Remember that the dust produced in the course of wear of frictional overlays of the conducted clutch plate may contain noxious to health asbestos. Do not blow off dust compressed air and try not to inhale it. Do not apply to rubbing of components of coupling solvents on an oil basis, - use only special brake cleaners or pure methyl alcohol. Put the used rags before utilization in hermetically closed container. |
REMOVAL
|
|
|
1. Disconnect a negative wire from the battery.
|
|
If the stereosystem established on the car is equipped with a security code before disconnecting the battery make sure that you have the correct combination for input of the audio system in action! |
2. Remove the transmission (see Removal and the RKPP installation).
|
|
3. Remove the lever of switching off of coupling from a spherical hairpin, then remove the release bearing from the lever. |
|
|
CHECK
|
|
|
|
Holding the bearing for an external holder, press two fingers internal and rotate it. The bearing has to rotate freely and silently, otherwise it needs to be replaced. Wipe the bearing with pure rags and examine on existence of signs of wear, cracks and other mechanical damages. Usually replacement of the release bearing is made every time at service of components of coupling. Do not wash out the bearing in solvent in order to avoid violation of tightness of its assembly at all. Check the lever of switching off of coupling for existence of cracks and signs of deformations. |
|
|
INSTALLATION
|
|
|
|
1. Grease with refractory lubricant a surface of the holder of the bearing of a peval. |
|
|
2. Grease with the same lubricant a nest under landing of a spherical finger from a reverse side of assembly of the lever of switching off, and also a nest under landing of a pusher of the executive cylinder. |
3. Put the fixing spring of a spherical support and the release bearing in assembly of the lever of switching off of coupling.
4. Put the release bearing on the holder of the forward bearing of a main shaft of the transmission, at the same time passing the end of the lever of switching off through an opening in a coupling casing. Densely put a switching off fork on a sharovy finger of a spherical support.
5. Slightly grease with refractory lubricant the surface of the release bearing contacting to petals of a diaphragm spring.
6. Further installation is made as it should be, the return to an order of dismantle of components. |
|
|
|