Nissan Maxima QX
+ Cars of the Nissan Maxima brand
+ Maintenance instruction
+ Settings and routine maintenance
+ Engine
+ Cooling systems, heating
+ Power supply system and release
+ Engine electric equipment
+ Control systems of the engine
+ Transmission
- Coupling and power shafts
General information
Coupling - the general information and check of a condition of components
Removal and installation of the main cylinder of coupling
Removal and installation of the executive cylinder of coupling
Removal of air from a hydraulic path of the drive of switching off of coupling
Removal, check of a state and installation of components of assembly of coupling
Removal, check of a state and installation of the release bearing and lever of switching off of coupling
Adjustment of a pedal of coupling
Check of serviceability of functioning and replacement of the sensor switch of disconnection of a chain of a starter
Power shafts - the general information and check of a state
Removal and installation of power shafts
Check of a state and replacement of assembly of the basic bearing
Replacement of protective covers and check of a condition of CV JOINTS
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
|
General information
The present Chapter is devoted to the components located between a back part of the engine and forward (leading) wheels of the car. According to the destination the considered components can be broken into two categories: coupling and power shafts. Descriptions of a design and the principle of action of each of separate knots, and also procedures of check of a state, removal, dismantling and recovery repair of the components entering into both groups are provided in the following Sections.
As the most part of the procedures described in the present Chapter is made under the car, special attention should be paid to reliability of fixing of the last in the lifted situation. |
|