Nissan Maxima QX
+ Cars of the Nissan Maxima brand
+ Maintenance instruction
+ Settings and routine maintenance
+ Engine
+ Cooling systems, heating
+ Power supply system and release
+ Engine electric equipment
+ Control systems of the engine
+ Transmission
- Coupling and power shafts
General information
Coupling - the general information and check of a condition of components
Removal and installation of the main cylinder of coupling
Removal and installation of the executive cylinder of coupling
Removal of air from a hydraulic path of the drive of switching off of coupling
Removal, check of a state and installation of components of assembly of coupling
Removal, check of a state and installation of the release bearing and lever of switching off of coupling
Adjustment of a pedal of coupling
Check of serviceability of functioning and replacement of the sensor switch of disconnection of a chain of a starter
Power shafts - the general information and check of a state
Removal and installation of power shafts
Check of a state and replacement of assembly of the basic bearing
Replacement of protective covers and check of a condition of CV JOINTS
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
|
Removal and installation of the main cylinder of coupling
Components of assembly of the main cylinder of coupling
|
|
|
1 — the Case
2 — the Tank of hydraulic liquid
3 — a tank Cover
4 — the Returnable spring
5 — Sealing cuffs
6 — the Piston |
7 — a valve Emphasis (acts at dismantle of a spring and the piston, 1.5 ÷ 2.9 Nanometers)
8 — the Pusher
9 — the Emphasis
10 — the Lock ring
11 — the Boot
12 — the Lock-nut (8 ÷ 11 Nanometers) |
REMOVAL
|
|
|
1. The design of the main hydraulic cylinder of coupling is presented on an illustration.
2. Disconnect a negative wire from the battery.
|
|
If the stereosystem established on the car is equipped with a security code before disconnecting the battery make sure that you have the correct combination for input of the audio system in action! |
|
|
3. Under the dashboard take a fixing pin and disconnect a cutting finger of a pusher of the main hydraulic cylinder from the coupling pedal lever. |
|
|
4. Remove the pump of the device of automatic control of the speed (ASCD). Disconnect from assembly of the main cylinder of coupling the hydraulic line, - in order to avoid a rounding off of shlits of a nut, it is reasonable to make weakening of nipple knot by means of a special cap key with a cutting head. Prepare rags for collecting the spilled hydraulic liquid.
|
|
In order to avoid damage of a paint and varnish covering do not allow hit of brake fluid on the painted body surfaces. |
|
|
|
5. Give nuts of fastening of the main cylinder on a back partition of a motive compartment. Remove Assembly of the main cylinder (try not to spill brake fluid). |
|
|
INSTALLATION
|
|
|
1. Start assembly of the main cylinder on the regular place and fix it by nuts, having by hand tightened the last.
2. Connect the hydraulic line to the main cylinder, - try not to warp a cap nut of the nipple socket in order to avoid irreversible damage of the last owing to failure of a carving.
3. Strongly tighten fixing nuts and the union of the hydraulic line.
4. Connect a cylinder pusher to a pedal of coupling and record a new pin a cutting finger.
5. Fill in in the tank necessary amount of the DOT 3 brake fluid (see the Head Nastroyki and routine maintenance), then give from a path air traffic jams (see the Section Removal of Air from a hydraulic path of the drive of switching off of coupling).
6. Check correctness of installations of height and a free wheeling of a pedal of coupling, in case of need make the corresponding adjustment (see the Section Adjustment of a Pedal of Coupling). |
|
|
|