Nissan Maxima QX

since 1993 release

Repair and operation of the car



Nissan Maxima QX
+ Cars of the Nissan Maxima brand
+ Maintenance instruction
+ Settings and routine maintenance
+ Engine
+ Cooling systems, heating
+ Power supply system and release
+ Engine electric equipment
- Control systems of the engine
   General information
   System of onboard diagnostics (OBD) - the principle of functioning and codes of malfunctions
   Removal and RSM installation
   Check of serviceability of a state, replacement and adjustment of the sensor of provision of a butterfly valve (TPS)
   Check of a state and replacement of the sensor of measurement of mass of an air stream (MAF)
   Check of a state and replacement of the sensor of absolute pressure in the pipeline (MAR)
   Check of a state and replacement of the sensor of temperature of the soaked-up air (IAT)
   Check of a state and replacement of the sensor of temperature of cooling liquid of the engine (EST)
   Check of a state and replacement of the sensor of provision of a bent shaft (ICR)
   Check of a state and replacement of the sensor of position of the camshaft (SMR)
   Check of a state and replacement of the sensor switch of pressure in system of hydrostrengthening of a wheel (PSP)
   Check of a state and replacement of the oxygen sensor (l-probe)
   Check of a state and replacement of the sensor of a detonation
   Check of a state and replacement of the sensor of temperature of fuel of speed of the movement of the car (VSS)
   Check of a state and replacement of the sensor of speed of the movement of the car (VSS)
   Check of a state and replacement of components of system of stabilization of turns of idling
   Control system of functioning of the power valve
   System of the operated ventilation of a case (PCV)
   System of recirculation of the fulfilled gases (EGR) - the general information, check of a state and replacement of components
   System of catching of fuel evaporations (EVAP) - the general information, check of a state and replacement of components
   The catalytic converter - the general information, check of a state and replacement
+ Transmission
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment

Removal and RSM installation

 PERFORMANCE ORDER

 The models of cars considered in the present manual are equipped with system of additional safety (SRS). Before starting performance of any works near the block of a safety cushion, a steering column or the dashboard, disconnect SRS in order to avoid getting injured at its casual operation (see the Head Onboard electric equipment). It is easy to distinguish an electrical wiring of a chain of SRS on yellow color of isolation.

 In order to avoid damage of RSM by the electrostatic category, try not to touch contact plugs of the module. Whenever possible you make self-grounding.

Every time at shutdown of the rechargeable battery comes cancellation of working parameters from memory of RSM that can lead to violation of stability of turns of the engine the first several minutes after implementation of the first start.


1. The module of management of RSM is placed in assembly of the central console of the car, to the right of the accelerator pedal.
2. Disconnect a negative wire from the battery.

 If the stereosystem established on the car is equipped with a security code before disconnecting the battery make sure that you have the correct combination for introduction of the equipment to action!

3. Remove panels of side finishing in front of the central console.

4. Disconnect an electrical wiring from RSM.

5. Turn out bolts of fastening of a basic arm of the module of management.

6. Carefully take assembly of the module from under the dashboard.
7. Installation is made upside-down.