Nissan Maxima QX

since 1993 release

Repair and operation of the car


Nissan Maxima QX
+ Cars of the Nissan Maxima brand
+ Maintenance instruction
+ Settings and routine maintenance
+ Engine
+ Cooling systems, heating
- Power supply system and release
   General information
   Dropping pressure in a power supply system
   Check of serviceability of functioning of the fuel pump, measurement of pressure of fuel
   Check of a state and replacement of fuel lines and their nipple connections
   Removal and installation of the fuel pump
   Check of a state and replacement of the sensor of fuel consumption
   Removal and installation of the fuel tank
   Cleaning and repair of the fuel tank - general information
   Removal and installation of assembly of the air cleaner
   Removal, installation and adjustment of a cable of an accelerator
   System of electronic injection of fuel (EFI) - the general information
   Check of serviceability of functioning of system of injection
   Check of a state and replacement of the case of a throttle
   Removal and installation of the regulator of pressure of fuel
   Removal and installation of the fuel highway and injectors of injection
   Check and adjustment of turns of idling
   System of release - the general information
+ Engine electric equipment
+ Control systems of the engine
+ Transmission
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment

Removal and installation of assembly of the air cleaner

Details of installation of assembly of the air cleaner and the accompanying components on models 1993 and 1994 of of the issue.

1 — Perepuskna an air hose of the IAC valve
2 — the Sensor of mass of an air stream
3 — the Top section of a casing of the air cleaner
4 — Clamps of fastening of a casing of the air cleaner

5 — the Lower section of a casing of the air cleaner
6 — the Reception air duct
7 — Fixing collars


Details of installation of assembly of the air cleaner and the accompanying components on models since 1995 of the issue.

1 — the Hose of ventilation of a case
2 — the Resonator of an inlet air path
3 — the Sensor of mass of an air stream
4 — the Sensor of temperature of the soaked-up air
5 — the Top section of a casing of the air cleaner

6 — Clamps of fastening of a casing of the air cleaner
7 — the Lower section of a casing of the air cleaner
8 — the Reception air duct
9 — Fixing collars


 PERFORMANCE ORDER

1. Disconnect a negative wire from the battery.

If the stereosystem established on the car is equipped with a security code before disconnecting the battery make sure that you have the correct combination for input of the audio system in action!

2. Disconnect an electrical wiring from sensors of mass of an air stream and temperature of the soaked-up air.
3. Release a clamp of fastening of the sensor of mass of an air stream on an inlet sleeve / resonator.
4. Release spring clamps, remove the top section of a casing of the air cleaner in assembly with the sensor of measurement of a workshop of car service of an air stream.

5. Turn out three fixing bolts and accurately take the lower section of a casing of assembly of the air cleaner from a motive compartment.

6. Installation is made upside-down.