Nissan Maxima QX

since 1993 release

Repair and operation of the car



Nissan Maxima QX
+ Cars of the Nissan Maxima brand
+ Maintenance instruction
+ Settings and routine maintenance
+ Engine
+ Cooling systems, heating
- Power supply system and release
   General information
   Dropping pressure in a power supply system
   Check of serviceability of functioning of the fuel pump, measurement of pressure of fuel
   Check of a state and replacement of fuel lines and their nipple connections
   Removal and installation of the fuel pump
   Check of a state and replacement of the sensor of fuel consumption
   Removal and installation of the fuel tank
   Cleaning and repair of the fuel tank - general information
   Removal and installation of assembly of the air cleaner
   Removal, installation and adjustment of a cable of an accelerator
   System of electronic injection of fuel (EFI) - the general information
   Check of serviceability of functioning of system of injection
   Check of a state and replacement of the case of a throttle
   Removal and installation of the regulator of pressure of fuel
   Removal and installation of the fuel highway and injectors of injection
   Check and adjustment of turns of idling
   System of release - the general information
+ Engine electric equipment
+ Control systems of the engine
+ Transmission
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment

Removal and installation of the regulator of pressure of fuel

See preventions at the beginning of the Section Dropping Pressure in a power supply system.


 PERFORMANCE ORDER

1. Dump pressure in a power supply system (see the Section Dropping Pressure in a power supply system). Disconnect a negative wire from the battery.

If the stereosystem established on the car is equipped with a security code before disconnecting the battery make sure that you have the correct combination for input of the equipment in action!

2. Disconnect from the case of a throttle and the air cleaner assembly of an inlet air duct with the resonator.

3. Carefully wipe the regulator of pressure of fuel and surfaces surrounding it. Disconnect from the regulator a vacuum hose and the line of return of fuel /

4. Turn out two fixing screws and remove assembly of the regulator from the fuel highway.

5. Grease a new sealing ring of the regulator with pure motive oil.
6. Installation is made upside-down. Track reliability of tightening of fixture.