|
1. Disconnect a negative wire from the battery.
|
|
If the stereosystem established on the car is equipped with a security code before disconnecting the battery make sure that you have the correct combination for input of the audio system in action! |
2. Prop up antiretractable boots back wheels of the car, cock the parking brake.
3. Weaken nuts of fastening of the right forward wheel. A car front also establish to Poddomkratta it on props, remove the right forward wheel.
4. Remove protection of a case and a loker of protection of an arch of the right forward wheel.
5. Take off driving belts (see the Head Nastroyki and routine maintenance).
6. Remove from a forward cover of the GRM drive the sensor of provision of a bent shaft (see the Head of the Control system of the engine).
|
|
7. Having blocked шив a bent shaft from a provorachivaniye by means of a chain or tape key, give the central bolt of its fastening. |
8. Having hooked a pulley from two parties screw-drivers or big mount, carefully remove it from a shaft pin. In case of need use the Gripping stripper.
|
|
Start captures of a stripper only under a stupichny part of a pulley! |
9. Installation is made upside-down. Before landing of a pulley to a pin of a shaft track correctness of combination of a spline with a reciprocal groove. Tighten a fixing bolt with the required effort. |