Nissan Maxima QX

since 1993 release

Repair and operation of the car


Nissan Maxima QX
+ Cars of the Nissan Maxima brand
+ Maintenance instruction
+ Settings and routine maintenance
+ Engine
+ Cooling systems, heating
+ Power supply system and release
+ Engine electric equipment
+ Control systems of the engine
+ Transmission
+ Coupling and power shafts
- Brake system
   General information
   System of anti-blocking of brakes (ABS) - the general information and codes of malfunctions
   Replacement of brake shoes of disk brake mechanisms
   Removal and installation of supports of disk brake mechanisms
   Check of a state, removal and installation of a brake disk
   Replacement of boots of drum brake mechanisms of back wheels
   Removal and installation of wheel cylinders
   Removal and installation of the main brake cylinder
   Replacement of the dosing valve regulator
   Check of a state and replacement of brake lines and hoses
   Pumping of the brake system
   Check of serviceability of functioning/tightness, replacement and adjustment of the vacuum amplifier of brakes
   Adjustment of the parking brake
   Replacement of a cable(s) of the drive of the parking brake
   Adjustment of a pedal of a foot brake
   Check of serviceability of functioning and replacement of the sensor switch of stoplights
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment

Adjustment of a pedal of a foot brake

Adjusting height of a pedal in the released state

 PERFORMANCE ORDER

1. Unbend a carpet and an insulating overlay of the panel of a floor. At completely released pedal of a foot brake measure distance from a surface of a rubber overlay of a block of a pedal to a floor surface.

2. Compare result of measurement to requirements of Specifications. In case of need make the corresponding adjustment (see further).

3. Weaken a lock-nut behind a cutting finger of a pusher of the vacuum amplifier of brakes.

4. Rotation of a rod of a pusher achieve the required result.
5. Tighten a lock-nut.
6. Having finished adjustment, check the size of a free wheeling of a pedal.

Free wheeling of a pedal

 PERFORMANCE ORDER

1. Slightly press a pedal down and measure the size of its course until emergence of resistance to squeezing. Compare result of measurement to requirements of Specifications, in case of need make the corresponding adjustment.

2. Weaken a lock-nut of a cutting finger of a pusher of the vacuum amplifier.
3. Rotation of a rod achieve the required result.
4. Tighten a lock-nut.

Height of provision of a pedal in the squeezed-out state

 PERFORMANCE ORDER

1. At the working engine completely squeeze out a pedal of a foot brake and measure distance from a surface of a rubber overlay of its block to a floor.
2. If height of provision of the squeezed-out pedal appears below an admissible limit (see Specifications), check the brake system for existence of signs of development of leaks or mechanical damages of components.