Nissan Maxima QX

1. The receiver dehumidifier carries out a coolant accumulator role, and also serves for removal from system of moisture. When replacing large components of the air conditioning system (the compressor, the condenser, the evaporator), and also at hit in a refrigerator path of air assembly of an accumulator/dehumidifier is subject to replacement.
2. Make air conditioning system discharge in the conditions of a specialized workshop. Disconnect a negative wire from the battery.

If the stereosystem established on the car is equipped with a security code before disconnecting the battery make sure that you have the correct combination for input of the audio system in action!

3. Disconnect an electrical wiring from the cyclic sensor switch of a clutch coupling of the compressor in the top part of assembly of a receiver dehumidifier.

When replacing a receiver dehumidifier transfer the old sensor switch to the new block.

4. Disconnect from a receiver refrigerator lines, at once to a zakuporta the open ends of tubes and unions in order to avoid hit in system of dirt.

5. Weaken a coupling bolt and release assembly of a receiver dehumidifier from a fixing collar (a basic arm).

1. When replacing assembly of a receiver dehumidifier about 2 ounces (60 ml) of refrigerator oil which should be filled in the replaceable block will be required.
2. Establish assembly on the regular place and slightly tighten a coupling bolt of a fixing collar, having left to assembly some degree of freedom necessary at connection of hydraulic lines.
3. Connect inlet and final refrigerator lines (before joining of nipple knots oil new sealing rings pure refrigerator) to assembly. Having finished connection of lines, strongly tighten a coupling bolt of a fixing collar.
4. Connect a negative wire to the battery.
5. Make charging of system and its check on leaks in the conditions of a specialized workshop.