Nissan Maxima QX

since 1993 release

Repair and operation of the car



Nissan Maxima QX
+ Cars of the Nissan Maxima brand
+ Maintenance instruction
+ Settings and routine maintenance
+ Engine
- Cooling systems, heating
   General information
   Antifreeze - general information
   Check of serviceability of functioning and replacement of the thermostat
   Check of a condition of fans of the cooling system and chains of their inclusion, replacement of components
   Removal and installation of a radiator and expanded tank of the cooling system
   Check of a state and replacement of the water pump
   Check of serviceability of functioning and replacement of the block of the sensor of the measuring instrument of temperature of cooling liquid
   Check of serviceability of functioning of a driving electric motor of the fan of a heater and condition of components of its electric chain, …
   Removal and installation of an electric motor of the drive of the fan of a heater
   Removal and installation of assembly of the control panel of functioning of a heater and conditioner of air, adjustment of a driving cable
   Removal and installation of the heat exchanger of a heater
   Check of serviceability of functioning and service of systems of heating and air conditioning
   Removal and installation of a receiver dehumidifier To/in
   Removal, service and installation of the K/V compressor
   Removal and installation of the K/V condenser
+ Power supply system and release
+ Engine electric equipment
+ Control systems of the engine
+ Transmission
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment

Removal and installation of assembly of the control panel of functioning of a heater and conditioner of air, adjustment of a driving cable

The cars considered in the present manual are equipped with system of additional safety of SRS better known as a safety cushion. Before performing any works near assembly of a pillow or a steering column, without fail disconnect system in order to avoid getting injured as a result of its casual operation, - disconnect from the battery at first a negative, then positive wire and wait not less than two minutes before starting service of the components located near sensors of the directed overloads (see the Head for Onboard electric equipment). Isolation and contact sockets of an electrical wiring of a chain of SRS are painted in bright yellow color. It is not necessary to connect any diagnostic units to this chain!


 PERFORMANCE ORDER

1. Remove the central facing of the dashboard (see the Head Kuzov).

2. Turn out four screws of fastening of assembly of management to the dashboard.

3. Take assembly from the landing nest in the panel and disconnect an electrical wiring.
4. The description of procedures of check of the switch of the choice of the high-speed modes of the fan of a heater see in the Section Check of Serviceability of Functioning of a Driving Electric Motor of the Fan of a Heater and Condition of Components of Its Electric Chain. For extraction of switches from the panel it is necessary to remove from handle levers, to turn out four screws of fastening of a casing of the printed circuit board, then to wring out plastic lock uvulas from the back party of the corresponding switch and to release it from the panel.
5. Installation is made upside-down.