|
1. Hang out the unit from above on the winch or a beam and remove the transmission (see the Head the Transmission). Remove a flywheel / a driving disk (see the Section Removal and installation of a flywheel / a driving disk).
|
|
2. Having accurately hooked the screw-driver, take an old epiploon from a landing nest in the holder. |
|
|
3. Grease a pin of a bent shaft and a sponge of a new epiploon with universal lubricant. Landing of an epiploon is carried out by means of a mandrel as which the face head of the corresponding size, or a piece of a pipe of suitable diameter can be used. As a last resort, you prostozastuchit an epiploon in a nest a stupid drift. Track perpendicularity of landing of an epiploon in a nest.
|
|
The epiploon has rather rigid sponges which are easy for damaging, observe extreme care! Landing is carried out not more deeply than aflush with the holder's back. |
|
4. Further installation is made as it should be, the return to an order of dismantle of components.
5. Start the engine and check its existence of signs of leak of oil. |