|
|
Some of the models considered in the present manual are equipped with safety cushions, - without fail disconnect SRS at service of the components located near pillows (see the Head Onboard electric equipment). |
1. Perform procedures of paragraphs with 8 on 12 Sections Check, adjustment and replacement of a cable of gear shifting.
2. Disconnect a cable of the drive of blocking of a key from the electromagnetic valve of blocking of switching and release it from a basic arm in a forward part of the basis of the lever of the selector (see the Section System of Blocking of Switching of Transmission - the general information, check of a state and replacement of components).
|
|
3. Give two forward nuts of fastening of assembly of the lever of the selector. |
4. The car also establish to Poddomkratta it on props.
5. From below give two back nuts of fastening of the lever of the selector to a floor.
6. In interior of the car disconnect all electrical wiring which can interfere with dismantle of lever assembly, then separate the last from the panel of a floor and remove it from the car.
7. Installation is made upside-down. Do not forget to adjust a driving cable (see the Section Check, adjustment and replacement of a cable of gear shifting). |