Nissan Maxima QX
+ Cars of the Nissan Maxima brand
+ Maintenance instruction
+ Settings and routine maintenance
+ Engine
+ Cooling systems, heating
+ Power supply system and release
+ Engine electric equipment
+ Control systems of the engine
- Transmission
+ 5-staged manual box of gear shifting (MBGS)
- 4-staged automatic transmission (AT)
General information
Failure diagnostics of AT/CVT - the general information
Check, adjustment and replacement of a cable of gear shifting
Removal and installation of the lever of the AT selector
System of blocking of switching of transmission - the general information, check of a state and replacement of components
Check, replacement and adjustment of the sensor switch of permission of start
Removal and installation of automatic transmission
Capital repairs of AT
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
|
Check, adjustment and replacement of a cable of gear shifting
CHECK
|
|
|
Transfer the selector lever from situation "P" to situation "1", - when passing each of ranges the click of the corresponding clamp has to be felt. If clamps do not work, or indications of the indicator of position of the lever do not correspond to really chosen AT mode, make adjustment of a driving cable of management of switching of transmission. |
|
ADJUSTMENT
|
|
|
1. Transfer the selector lever to situation "P".
2. The car also establish to Poddomkratta it on props.
|
|
3. On models 1993 and 1994 of of the issue weaken lock-nuts of fastening of a cable to a switching rod. On models since 1995 of the issue weaken a lock-nut of fastening of a cable on the lever of manual gear shifting. Transfer the hand lever to situation "P". |
|
|
4. On models 1993 and 1994 of of the issue tighten a back lock-nut so that it nestled on a switching rod (not strongly - before the choice of a weak point of a cable), then tighten a forward lock-nut. On models since 1995 of the issue delay a cable down and, holding it and the hand lever in this situation, tighten a lock-nut. |
5. Transfer the selector lever from situation "P" to situation "1". Make sure of smoothness of the course of the lever.
6. Lower the car on the earth. |
|
REPLACEMENT
|
|
|
|
Some of the models considered in the present manual are equipped with safety cushions, - without fail disconnect SRS at service of the components located near pillows (see the Head Onboard electric equipment). |
1. Remove the central console and facing of the central section of the dashboard (see the Head Kuzov).
2. Remove the handle from the AT selector lever.
|
|
3. Remove the display panel of the index of provision of transmission. |
|
|
4. Disconnect a driving cable from the selector lever. |
|
|
5. Release a cable from the basis of lever assembly. |
6. The car also establish to Poddomkratta it on props.
7. Disconnect a cable from the lever of manual switching to transmissions. On models 1993 and 1994 of of the issue the cable fastens by means of a clip, - on models since 1995 the issue is used a nut.
|
|
8. Remove the With-shaped clamp of fastening of a cable in a basic arm on a transmission case. Release a cable from an arm. |
9. Installation is made upside-down. Do not forget to adjust a cable (see above). |
|
|
|